5
My reformat is complete
Rochelle
Misc.
The reformatting of my computer is now complete. Of course, it took much longer than I anticipated. Isn’t that always the way with reformats?
All seemed to go well until I wanted to install my laser printer. Darned if it won’t recognize it. For all the times I’ve reformatted, which is more than I care to admit, I’ve never had this problem. Nothing I tried would get it to install, and I’m fairly tech savvy. If any one reading this has suggestions please share because I’m getting ready to move this 50+ pound printer over to my husband’s computer and install it there, which I really don’t want to do.
On the plus side, everything else installed perfectly and my system is humming along the way it should. Hopefully, though, I won’t need to do this again for quite some time (my fingers are crossed as I type this).
Today I will go through the questions left in the comments of various blog posts and answer them. So look for the answers to your questions if you asked them.
Rochelle
Related Posts:
Is it USB? Did you install and update the usb root drivers for your mainboard? Did you try another usb port? Did you load the drivers, restart and then plug in the printer? Are you going through a USB hub? If so, try plugging it direct into your PC.
Is is parallel? Your BIOS setting shouldn’t have changed but you can always check your BIOS to make sure onboard parallel is on and what mode it is et to. You can also check that the USB legacy is turned on possibly???
I could be more helpful if you told me the interface, make, model, etc…
thanks,
Jonathan
Jonathan,
Thank you so much for your help in getting my printer installed! If not for you I would be preparing to move this thing but now I don’t need to.
Rochelle
Hi Rochelle:
I didn’t know where to put this but thought this was as good as any spot.
Nursehoney from the BANS site told me I should write you and see if you can help me.
I have 3 sites.
#1 is http://www.mybigchrometruck.com
#2 is http://www.rshades4u.com
#3 is http://www.buywoodcarvingtools.com
I’ve attempted to up date them to the new epn info and now have the following:
#1 has been updated and has the Campaine ID in and is keeping it but the admin site doesn’t have the epn in front of the V.3 in the title.
Will this work this way?:
#2 has the update done to it and will load the site but when I try to get into the admin site I get a whole page of errors that say that a bunch of things are missing.
#3 is updated and has the epn in the admin and the campaine ID in and should be ready to go.
The only problum I have with #3 is the left image at the top is under a tab and I can’t figure how to move the tab. I’ve left Mark a message but he hasen’t returned with the solution.
If you can help I’ll be happy to give you the passwords to look at things, and if not I understand. Any help will be apprecitated.
The other problum is that I’ve had these sites up for about 1 to 2 months or more and google doesn’t know their there. I’ve submitted them and submitted them to other directories and had others submitte them but nothing.
Any ideas???
Thanks
w.